Hi,

I'm trying to install & configure an annex box on my admin ws which is
on sol 10. The entry in my /etc/remote is as follows:

tc:\
:dv=/dev/term/a:br#9600:el=^C^S^Q^U^D:ie=%$e=^D:

I tip it in & power on the box & hold the test button until the power
light start blinking and release it. After waiting for a few minutes
which should have been 1 minute max, I don't see anything on my
terminal (i.e, monitor: except just a letter "Q~". The light pattern
on my tc is as follows:

Power: green
Unit: green
Net: green
Attn: off
Load: off
Active: blinking
Test: off

I already try on 2 different annex boxes & they both have the same
behavior.

Question: Is there a coincidence that both of my tc are bad? If they
are not, is there a way to fix it?

I don't know annex box very well & hope some experts here could light
up the darkness for me Any helps/ suggestions are appreciated.

TIA,
-Chris