HI,

Michael Myers wrote:
> Hello to all.
> Finally my sym22801 controller is arrived.
> I first installed NetBSD-3.0 just for a fast test on a Quantum Viking2 9 gb
> scsi (booting from the IDE-CD).
> Now, I have done an nvalias for the Quantum Disk scsi and then a setenv
> boot-device and it boots perfectly ! ;-)
> But... I have a little problem.
> Today , I tried to add a scsi cdrom (Teac CD532s SCSI) but I can't boot from
> it. I think I have to put a correct address for this cdrom.
> This is my output from "show-disks" :
> /pci@1f,0/pci@1/scsi@1/disk
> /pci@1f,0/pci@1/scsi@1,1/disk
> And follows the list of ide devices.
> If I do "probe-scsi-all", I have the following output :
>
> /pci@1f,0/pci@1/scsi@1,1
>
> /pci@1f,0/pci@1/scsi@1
> Target 0
> Unit 0 Disk Qauntum Viking II 9.1 WLS
> Target 4
> Unit 0 Removable ReadOnly device TEAC CDROM CD-532S
> ok
>
> I think my problem is on that "Target 4" , I think I have to put something
> to boot from this "4". I googled a bit, but I can't solve my problem.
> Can someone help me ?
> Thanks to all !
>
>

best is to change the SCSI ID on the CD to 6, 4 is often used for tapes.

/michael