shaab.mohagir@bonbon.net (shaab mohagir) schrieb:

>My problem started when I tried to install SuSE 9.0 on a Dell
>PowerEdge server 2300, Yast2 kept saying "no hard disks are found...."

Did you load the modules needed?

>Here is what I found, after digging around on the internet I learened
>that in SuSE9 the default boot loaded is set to GRUB, and that GRUB
>fails to identify SCSI drives, on the other hand LILO does, so the
>advise was to make LILO as the default bootloader!

??? I installed more than one SuSE 9.0 on a SCSI system. GRUB boots
just fine.

Your problem is not the boot loader. Tell Yast to load scsi modules
during installation. Then it will generate a proper initrd, that will
load the needed drivers on boot, may it be lilo or grub.
Eggert