Using AIX 5.3L
Priting from an application called Unform, which sends a PCL formatted
print job to a print queue.

The printer is an HP 1022nw, connected as an
hpJetDirect/hewlett-packard/hplj-4+ printer.

These are the current print options:
Print QUALITY 600 +

----------- Job Processing Options ------------
PAGE NUMBER where printing should begin [1] +#
Print file TYPE p +
Pre-processing FILTER NAME [] +
INITIALIZE printer? no initialization +
RESTORE printer? yes +

----------- Text Formatting Options -----------
TOP MARGIN (lines) [0] +#
BOTTOM MARGIN (lines) [0] +#
Number of columns to INDENT [0] +#
WRAP long lines? no +
Add LINE FEED or CARRIAGE RETURN LF->CRLF VT->CRVT +
CODE PAGE of print file [ISO8859-1] +
TITLE STRING for 'pr' filter []
LINES per page [00] +#
COLUMNS per page [255] +#

------------- Paper/Page Options --------------
Page ORIENTATION portrait +
Input PAPER SOURCE standard 250-sheet ca> +
PAPER SIZE override for input paper source letter +
DUPLEX output simplex (single-sided> +

--------- Header/Trailer Page Options ---------
SEPARATOR PAGES none +
HOSTNAME for "PRINTED AT:" on HEADER PAGE []

------------- Messages/Diagnostics ------------
DIAGNOSTIC LEVEL (normal) - print job;> +


The print job prints fine, but after each job I get a blank page. Is
there a configuration switch somewhere that will stop that from
happening? If I configure the printer as a generic/ascii printer, I get
an option to disable sending a form feed when the job is done, but that
option doesn't exist when configuring the printer as a laserjet. I
suppose I could just set the printer up as generic/ascii, but I was
wondering if there is a setting I'm missing that would let me set it up
as a laserjet, since that's what it is...

Thanks,
Tim