AngieW wrote:
>
> Hi All
> Jean-Pierre Radley wrote:
> > AngieW typed (on Thu, Dec 09, 2004 at 07:20:48AM -0800):
> > | Hi All,
> > | Ive searched the archive for this but did not really find a
> resolution!
> > | Nice new fresh install of osr506 with the stanard sco ppp
> > | I removed sco ppp and rebooted.
> > | I then added 506a and rebooted.
> > | I then added mstppp 2.1.2 and rebooted again after the kernel
> relink.
> >
> >
> > 2.1.2 ??
> > Not 2.1.5, or 2.1.4 ?
>
> It's 2.1.2a as I had tried 2,1,5a from the 507 cd with the same result
> befoer the
> server was reinstalled from square one.
> My one internal 506 box is what I used to test bed this and I used
> 2.1.5a from the
> 507 cd without any problems. My 506 media kit is out on loan so I've
> not been
> able to try 2.1.4a.
>
> Any other ideas?
>
> I can't even hide the messages on tty12 with cn.console=12 in a the
> bootstring :-(
>
> They don't seem to cause any problem!
>
> >
> > | The dreadfull message that follows now pops up rather regularly.
> > | This is a line from syslog
> > | Dec 9 17:01:44 scosysv tunioctl(0): Unknown ioctl 0x00000005
> >
> > --
> > JP
>
> Cheers
> Ang
> --
> angiedoteohdotcodotza

Check to see when MSTPPP is up and running that the remote gateway,
and DNS servers entries are correct and are responding.

I have had better luck running the modem in full HW flow control mode,
which requires the MSTPPP config lines to be editted. In my setup I
used "rtscts-rtsflow" in the Account file.

Mike

--
Michael Brown