I am attempting to install SCO Openserver 5.0.5 on replacement
hardware. The new machine has 2 SCSI controllers - a LSI Logic 21040
(which uses the slha driver) to which a tape drive is attached and a LSI
Logic 21320 (which uses the lsil driver) which attaches to the only disk
drive - a Fuji MAP3367NP (36 G) drive. The bios lists the drive as HBA
1, ID 0, LUN 0.

At the boot prompt from the CD install I have tried all combos of link,
followed by lsil Sdsk=lsil(X,Y,0,0) but the hard drive is never
recognized. The hardware info screen that comes up when attempting the
install does show the 2 channels(?) of the 21320 adapter but no boot
device. For the time being, I am not even attempting to load the slha
driver for the other card attached to the tape drive.

The machine is functional - it boots to a FreeDos that was loaded on the
hard drive.

Mike