On Feb 21, 11:30 am, ~David~ <shadowe...@gmail.com> wrote:
> I've had this problem and it's usually in the kernel config. Make sure your
> filesystem (ext2 or ext3 or sun or...) is supported, as well as the IDE chipset
> in the motherboard (ICH3 or VIA) or use generic IDE chipset support.
> Also make sure the grub or lilo boot config file is set to boot to the correct
> partition.
>
> Good luck
> David
>

I found the livecd's kernel config under /proc/config.gz but this
would be only a temporary option. Before I do that, I'm figuring I
should give my kernel another try, so I'm enabling CMD646 in the IDE
section to make it to work, and I'm rebuilding my kernel right now and
in few minutes I'll know if I was righ.

This Blade machine is one little buggy piece of hardware..

Igor Putina