SEO

#1 (**permalink**) 04-21-2008, 05:46 AM

I have several questions on a new install of SCO 6.0.0. I have not
done these or it have been several years I have not done them.

1) How do I change keyboard / mouse from PS/2 to USB version?

2) How to add second "physical" hard drive that is already partitioned
but has not "slice" / file systems?

History of this server in question:

This is a new IBM x3400 Quad-core system. Due to software firmware
"conflicting" setting recommendations, disabling the ASF on built-in
BroadComm network adapter (SCO 5.0.7 install before upgrade to 6.0.0,)
the motherboard controller BCM shutdown the board. After 4
replacements, under warranty, was told to not to touch ASF settings
(ok, will use 6.0.0) and found out today BCM reset method. System is
work correctly however will not complete the install if using USB
keyboard / mouse and USB floppy drive for additional HBA install.
Used PS/2 keybaord to complete the install and once IBM field service
reps fixed USB issues, switched to USB keyboard / mouse. Now the
console is displaying "Integral console keyboard not found" warning.
Since this will go to a client's site, I would like to remove this
message.

#2 (**permalink**) 04-21-2008, 07:40 AM

On 15 Apr, 16:46, smlunatick <yves...@gmail.com> wrote:
> I have several questions on a new install of SCO 6.0.0. I have not
> done these or it have been several years I have not done them.
>
> 1) How do I change keyboard / mouse from PS/2 to USB version?

To change the mouse use:

mkdev mouse

To change keyboard I would assume you just reboot the server
with the USB keyboard?

> 2) How to add second "physical" hard drive that is already partitioned
> but has not "slice" / file systems?

mkdev hd

John

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

SEO

Questions after successful SCO 6.0.0 install