SEO

#1 (**permalink**) 01-04-2008, 10:47 PM

Hello,

I am trying to setup a HACMP cluster on a Single node. I know this
sounds stupid. I need to do this for a testing purpose. My RS/6000 has
2 enet interface cards. I need to instll and configure HACMP 5.1 on
AIX 5l V5.2.Any suggestions will be appreciated.

Thanks
vijay

#2 (**permalink**) 01-04-2008, 10:47 PM

"vijay kumar" <t_vijaykumar@yahoo.com> schrieb im Newsbeitrag
news:a6bc21c3.0406161331.3cc53963@posting.google.c om...
> Hello,
>
> I am trying to setup a HACMP cluster on a Single node. I know this
> sounds stupid. I need to do this for a testing purpose. My RS/6000 has
> 2 enet interface cards. I need to instll and configure HACMP 5.1 on
> AIX 5l V5.2.Any suggestions will be appreciated.
>
> Thanks
> vijay

Hi vijay,

have seen this once with HACMP 4.1 or 4.2. It made quite sense then because
IBM had delivered just half of the ordered hardware and the admin in charge
for the project could not afford to loose any more time. It included a lot
(!) of ODM hacking but when the second node was deliverd it integrated
smoothly into this cluster (which then became a two node cluster). Nothing
that can be explained in a few lines here and I am not sure whether it is
possible with HACMP 5.1 at all. However, if you want to do it you might
start with taking a close look into the HACMP part of the ODM of a working
cluster.

Happy hackin'
Andreas

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

SEO

HACMP on a Single Node