SEO

#1 (**permalink**) 01-04-2008, 09:07 PM

AIXers,

Is there a way to get the hdisk/pdisk information from a SSA drive
when the drive has failed? I have a drive that's gone bad in a RAID
0/1 stripe set but when trying to get the hdisk/pdisk informtaion. I'm
unable to use the 'ssaxlate' command. How would I get around this to
replace the drive??

thanks

#2 (**permalink**) 01-04-2008, 09:07 PM

ucstyle@hotmail.com (Ken) wrote in message news:<d526473a.0312150755.6a5acb51@posting.google. com>...
> AIXers,
>
> Is there a way to get the hdisk/pdisk information from a SSA drive
> when the drive has failed? I have a drive that's gone bad in a RAID
> 0/1 stripe set but when trying to get the hdisk/pdisk informtaion. I'm
> unable to use the 'ssaxlate' command. How would I get around this to
> replace the drive??
>
> thanks

Go into smit and look at the SSA RAID Arrays sub-panel. Bring up the
option to change/show use of disk. The failed/rejected disks will be
listed at the top of the screen. From there, you can F6/ESC-6 to see
the commands that were used to get this information.

BV

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

SEO

pdisk/hdisk number from drive