SEO

I have a new blackberry pearl that charges properly w/out the uberry driver:

umass0 at uhub0 port 2 configuration 1 interface 1 "Research In Motion RIM
Composite Device" rev 2.00/2.00 addr 2
umass0: using SCSI over Bulk-Only
scsibus2 at umass0: 2 targets
sd0 at scsibus2 targ 1 lun 0: <RIM, BlackBerry SD, 0001> SCSI0 0/direct
removable
sd0: drive offline

$ usbdevs -v
Controller /dev/usb0:
addr 1: high speed, self powered, config 1, EHCI root hub(0x0000),
SiS(0x1039), rev 1.00
port 1 powered
port 2 addr 2: high speed, power 500 mA, config 1, RIM Composite
Device(0x8004), Research In Motion(0x0fca), rev 2.00, iSerialNumber ....


I've also run across the following:

http://wiki.colar.net/tethering_with...pearl_on_linux

which in turn made me aware of this:

http://off.net/cassis/protocol-description.html

Maybe something to knaw on..



In theory, around Thursday 23 August 2007 09:14:42 you wrote:
> I took notice of the uberry changes last night and gave them a try today.
> Now when I connect the device (blackberry 8300 or BB Curve) it increases
> the charge current properly and did fully charge the device. Usbdevs -v
> shows the power at 500mA for RIM Composite Device(0x0004), Research In
> Motion(0x0fca), rev 1.06. Excellent!! Now I no longer need to carry my
> charge in my laptop bag. I'm going to see if I can get the driver to load
> umass so I can access my memory card on the device again. I also have
> access to a lot of BB's including the curve, 8830, etc. Thanks! Brandon
> Sent via BlackBerry by AT&T



--
Todd Fries .. todd@fries.net

_____________________________________________
| \ 1.636.410.0632 (voice)
| Free Daemon Consulting \ 1.405.227.9094 (voice)
| http://FreeDaemonConsulting.com \ 1.866.792.3418 (FAX)
| "..in support of free software solutions." \ 250797 (FWD)
| \
\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\

37E7 D3EB 74D0 8D66 A68D B866 0326 204E 3F42 004A
http://todd.fries.net/pgp.txt