SEO

#1 (**permalink**) 01-05-2008, 11:59 AM

Hi,

I have a Sun 280R with a RSC card. I installed the software for it and
configured it without any trouble. Hooked it up to the network and he
connection is there, I can telnet to it and the card work ok. The one
exception is the console. I changed input-device and output-device to rsc
in the OBP, rebooted, but when I enter the 'console' command it just
freezes up.

Anyone seen this behaviour before?

Thanks in advance,

Sander

#2 (**permalink**) 01-05-2008, 12:00 PM

Sander,

the input-device and output-device need to be set to rsc-console. If I
recall, the documentation is wrong on this. The earlier RSC cards, such
as the ones in the E250 required rsc, but the newer "three port" cards
require rsc-console.

I'm working from memory here but I'm pretty sure that is right.

Regards

Duncan

Sander wrote:

>Hi,
>
>I have a Sun 280R with a RSC card. I installed the software for it and
>configured it without any trouble. Hooked it up to the network and he
>connection is there, I can telnet to it and the card work ok. The one
>exception is the console. I changed input-device and output-device to rsc
>in the OBP, rebooted, but when I enter the 'console' command it just
>freezes up.
>
>Anyone seen this behaviour before?
>
>Thanks in advance,
>
>Sander
>
>

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

SEO

Solaris 8; RSC card; console command doesn't work