SEO

#1 (**permalink**) 01-16-2008, 10:34 AM

Hey folks,

I am new to SVM multipathing.
Accoring to the Sun Docs I used
stsmeboot -e command to enable multipathing on the Solria 10 server.
When I used the format command it only shows two device on a
multipath. I also used the command
mpathadm list lu
and it only shows the same two devices.
What should I do to get all the devices to use multipating?
What should I do in order to verify that the configuration is working?
Any help on this would be greatly appreciated!

Thanks a million.

#2 (**permalink**) 01-16-2008, 10:34 AM

Hi,

you first have to adjust /kernel/drv/fp.conf and /kernel/driver/scsi_????
(Im not at my desk at the moment)

There also exists a "multipathing" doc on docs.sun.com

uxtuner

"learner" <Zabaloch@gmail.com> schrieb im Newsbeitrag
news:1184166727.603933.247640@g4g2000hsf.googlegro ups.com...
> Hey folks,
>
> I am new to SVM multipathing.
> Accoring to the Sun Docs I used
> stsmeboot -e command to enable multipathing on the Solria 10 server.
> When I used the format command it only shows two device on a
> multipath. I also used the command
> mpathadm list lu
> and it only shows the same two devices.
> What should I do to get all the devices to use multipating?
> What should I do in order to verify that the configuration is working?
> Any help on this would be greatly appreciated!
>
> Thanks a million.
>

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

SEO

MPxIO help1