Dear all

As for Sun hardware I'm quite an absolute beginner.
My Ultra 5 (270mhz, 512 ram, IDE CDROM, SUNPCi) works properly using
IDE disks.
I've got a LSI LOGIC sym22801 card in order to use scsi disks.
After pluggin the board and doing a "boot -r" I get the following
result:

WARNING: pcipsy0: ino 0x14 has been blocked
WARNING: glm0: interrupt #0 has been blocked
WARNING: pcipsy0: ino 0x15 has been blocked
WARNING: glm0: interrupt #0 has been blocked
WARNING: /pci@1f,0/pci@1/scsi@2 (glm0): Connected command timeout for
target 0.0
WARNING: /pci@1f,0/pci@1/scsi@2 (glm0): Connected command timeout for
target 0.0
WARNING: got SCSI bus reset

and so on until the last target.
The same result is reached using "boot cdrom".

I've googled for a couple of hours, but I've not seen infos about this
particular problem.
Any suggestion?

Thanks in advance, also for trying to understand my English :-)

Magenta