SEO

i purchased a 73gig sca hard drive in a sun 611 case some time ago,
and tried to attach it to a 'new' ultra-1. it was not recognized, no
matter what i tried. i eventually took the drive, attached a 50pin to
sca adapter, and put it on a sparc2 which is very reliable, and besides
has sformat working on it. it was attached at scsi station 0.
[format sees the drive but gives no useful error messages.]

this time the machine recognizes the drive, and here are the results:

sformat SCSI format/analysis/repair utilities
Release 3.4, Copyright J. Schilling

scsibus0:
c0t0d0 0,0,0 0) 'QUANTUM ' 'ATLAS10K2-TY734J' 'DDD6' Disk
c0t1d0 0,1,0 1) 'IBM ' 'DCHS09F CLAR09 ' '1919' Disk
0,2,0 2) *
c0t3d0 0,3,0 3) 'IBM ' 'DCAS-32160 ' 'S65A' Disk
0,4,0 4) *
0,5,0 5) *
0,6,0 6) *
0,7,0 7) *
Select target -1 (0 - 3)/<cr>:0
scsibus0 target 0:
c0t0d0 0,0,0 0) 'QUANTUM ' 'ATLAS10K2-TY734J' 'DDD6' Disk
0,0,1 1) *
0,0,2 2) *
0,0,3 3) *
0,0,4 4) *
0,0,5 5) *
0,0,6 6) *
0,0,7 7) *
Select lun -1 (0 - 0)/<cr>:0
scsibus0 target 0 lun 0
Device type : Disk
Version : 3
Response Format: 2
Capabilities : WBUS16 SYNC LINKED CMDQUE
Vendor_info : 'QUANTUM '
Identifikation : 'ATLAS10K2-TY734J'
Revision : 'DDD6'
Device seems to be: Generic CCS Disk.
sformat: I/O error. test unit ready: scsi sendcmd: no error
CDB: 00 00 00 00 00 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 70 00 02 00 00 00 00 0A 00 00 00 00 04 88 00 00 00 00
Sense Key: 0x2 Not Ready, Segment 0
Sense Code: 0x04 Qual 0x88 (logical unit not ready, cause not reportable) [No matching qualifier] Fru 0x0
Sense flags: Blk 0 (not valid)
cmd finished after 10.000s timeout 20s
sformat: Drive not ready.


can anyone make sense out of this? is this drive dead? is it
salvagable, and if so, how?

--
getting out of bed in the morning is an act of false confidence
- jules feifer
to email me, delete blackhole. from my return address