SEO

#1 (**permalink**) 03-28-2008, 04:31 AM

Has anyone experienced any issues installing a second CPU module?

The system boots with a single module ( I've tested booting using
either module in slot 0 )

When I boot with both installed I get an error from openboot:

Boot with diag-switch? set to true/max:

Diag Error:

POST toplevel failed:

CPU1
IO-Bridge0
Motherboard
Safari B

Hardware:

Openboot: 4.16.4
CPU Modules: USIII+ 900Mhz cu Version 2.2

Both CPU modules are good as I can boot using either in slot 0 - does
this mean that
the main board has a fault?

Thanks

#2 (**permalink**) 03-28-2008, 04:31 AM

<steve.g.szabo@gmail.com> wrote in message
news:b3df617e-734e-4bf3-a022-8d3d1a712059@u10g2000prn.googlegroups.com...
> Both CPU modules are good as I can boot using either in slot 0 - does
> this mean that
> the main board has a fault?

Are both CPUs the exact same speed?
Better yet if they're the exact same P/N as well.
There are two different kinds of 900 MHz CPUs and they can't be mixed and
matched.

If they're identical, then I'd say swap the slots the CPUs are in.
Should the error stick with slot 1, then it's probably the system board.
If the error moves to slot 0, then the new CPU is bad.

Trinean

#3 (**permalink**) 03-28-2008, 04:31 AM

On 2008-03-21, steve.g.szabo@gmail.com <steve.g.szabo@gmail.com> wrote:
> Has anyone experienced any issues installing a second CPU module?
>
> The system boots with a single module ( I've tested booting using
> either module in slot 0 )
>
> When I boot with both installed I get an error from openboot:

[ ... ]

> Both CPU modules are good as I can boot using either in slot 0 - does
> this mean that
> the main board has a fault?

Well ... I experienced a similar problem in a Sun Fire 280R,
which uses the same family of system boards and CPUs as the Sun Blade
1000 and 2000.

Except that I could get *no* diagnoistics out of the system with
two CPUs installed.

It turns out that someone had bumped the end of one CPU's
connector and it apparently shorted out the last few pin pairs on one
end. This apparently burned out something on the system board which was
necessary to allow two CPUs to co-exist. Either CPU would work fine on
its own.

I straightened out the pins and verified that they both worked
together in a SB-2000, so I ordered a replacement system board from an
eBay vendor.

That fixed things totally.

Since your error allows both boards to be present and gives you
some diagnoistcs, you may have a different problem.

Good Luck,
DoN.

--
Email: <dnichols@d-and-d.com> | Voice (all times): (703) 938-4564
(too) near Washington D.C. | http://www.d-and-d.com/dnichols/DoN.html
--- Black Holes are where God is dividing by zero ---

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

SEO

Sun blade 2000 2nd CPU module