SEO

#1 (**permalink**) 01-16-2008, 12:54 PM

I am curious, can the Sun V100 LOM be accessed directly from the
network using telnet (sort of like the E250 RSC console)? The
documentation doesn't seem to say that this can be done but when
running the 'show' command in LOM, it prints these variables:

ip-address not set
ip-netmask not set
ip-gateway not set

--
Akop Pogosian

This space has been accidentally left blank.

#2 (**permalink**) 01-16-2008, 12:54 PM

Akop Pogosian <akopps+usenet@ocf.berkeley.edu.remuvthis.com> wrote:
> I am curious, can the Sun V100 LOM be accessed directly from the
> network using telnet (sort of like the E250 RSC console)? The
> documentation doesn't seem to say that this can be done but when
> running the 'show' command in LOM, it prints these variables:

Not on a V100, no. Some (all?) of the newer machines have a LOM which
is accessable over both serial and ethernet, but on the V100's it's
serial only.

Scott

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

SEO

V100 LOM and network