SEO

I've just downloaded and burned the new Knoppix live eval cd. Below is
the limited directions on how to "install" to a harddrive.


A: In principal, yes (after all, the "master" system also runs on a hard
drive before it is burned to CD). However there is currently no
installation GUI for this, so installation to a hard drive should probably
only be attempted by more knowledgeable Linux users. Assuming the KNOPPIX
system has already booted, installation approximately follows this
procedure:
1.) initialize a free partition with the ext2 file system and mount it on
/mnt/knoppix, for example.
2.) cp -a /KNOPPIX/* /mnt/knoppix/
3.) set up /mnt/knoppix/etc/fstab and /mnt/knoppix/etc/lilo.conf for the
new system (Caution: symlinks in /boot initially point to the Ram
disk!), run lilo.
4.) mkdir /mnt/knoppix/home/knoppix && \
chown knoppix.knoppix /mnt/knoppix/home/knoppix
5.) Reboot, try the system out, fix any broken settings.
(No guarantees.)

Now I do have a harddrive set up as follows:

hdc1 ext2 space available 500 megs
hdc2 swap space available 500 megs
hdc3 ext3 space available 17 gigs

What do I need to look out for when setting this up? Should the drive be
reset with a 1 gig boot (hdc1) and set the /mnt/knoppix mount point
there? Or can I just fdisk the drive to two partitions. The primary/root
partition 17 gigs ext2 file system, and a 1 gig swap partition.

The pc where this will be running is a Dell p3 933 mz sis 6326 video card
265 megs ram, 3com nic, and built on board sound. All systems are
detedted and run when the Knopix cd is on the drive. I'd just like to run
it from the hd instead of the cd.


Thanks in advance.