I have a Sun netra T1 AC200 which is able to poweron from the LOM but
no output on the console than anymore. (I only hear the noise from the
now powered on machine. ;-) )

Any idea about whats wrong here?

Thank you in advance! Jan


LOMlite starting up.

CPU type: H8/3437, mode 3
Ram-test: 2048 bytes OK
Initialising i2c bus: OK
Searching for EEPROMs: 50(cfg)
I2c eeprom @50: OK
i2c bus speed code 01... OK
Probing for lm80s: 28
Initialising lm80 @28: OK
Probing for lm75s: none
System functions: PSUs fans breakers rails gpio temps host CLI ebus
clock

LOMlite console
lom>
LOM event: +0h0m0s LOM booted
lom>poweron
lom>
LOM event: +0h5m33s host power on


Than nothing more?

xcomm wrote:
> I have a Sun netra T1 AC200 which is able to poweron from the LOM but
> no output on the console than anymore. (I only hear the noise from the
> now powered on machine. ;-) )
>
> Any idea about whats wrong here?
>
> Thank you in advance! Jan
>
>
> LOMlite starting up.
>
> CPU type: H8/3437, mode 3
> Ram-test: 2048 bytes OK
> Initialising i2c bus: OK
> Searching for EEPROMs: 50(cfg)
> I2c eeprom @50: OK
> i2c bus speed code 01... OK
> Probing for lm80s: 28
> Initialising lm80 @28: OK
> Probing for lm75s: none
> System functions: PSUs fans breakers rails gpio temps host CLI ebus
> clock
>
> LOMlite console
> lom>
> LOM event: +0h0m0s LOM booted
> lom>poweron
> lom>
> LOM event: +0h5m33s host power on
>
>
> Than nothing more?
salut

try to switch to lom with "#."
and than type "console"

there is also a lom reset command. i can not remember...

cu

Salut Jordan,

> salut
>
> try to switch to lom with "#."
> and than type "console"

Yes - I can switch to the LOM> this way - thanks!

But, there is no real reaction on 'break', 'reset' or 'console'.

At least with 'reset' I see something happen, like the
'LOM event: +0h11m29s host reset'
and it's checking the CDROM,
but nothing more than and I will have to use the '#.' again.

Anymore ideas on this nasty problem appreciated!

BTW: The main board and CPU of the box are new ones as it was not
'poweron' at all before.

I also tried it now with disconecting the SCA drives and the CDROM,
but no difference...

So I see only the memory, the PSU or the smart card unit over as
posible hardware reasons. ???

Thank you in advance! Jan